Insert a flathead screwdriver or similar tool into the seam and gently pry the two halves of the camera apart. Be careful not to apply too much pressure, as this could damage the internal components. Once the camera is open, proceed with caution and avoid touching any of the exposed components. The red light of death is an occurrence when the camera malfunctions. It usually occurs when the camera has pieces dislodged from a drop or if there are damaged pieces in the camera. If this occurs then we recommend taking the camera apart and locating which pieces are damaged, The shell replacement guide located on the "Fujifilm Instax Mini 8 Open the latch that holds the back of the camera closed. There is a yellow mark in the upper corner. Place the film into the camera so that the yellow mark on the cartridge lines up with the yellow mark on the camera. The ‘open’ side of the film cartridge (the side with the notice that says not to push down on it) should be face down How to shoot pushed film. When you load film into your camera, you set the camera for the ISO for that film. To push the film, you must set the ISO higher than the ISO indicated on the film. By doing this, you’re telling your camera that the film is more sensitive to light than it is, thereby underexposing the film in capture. Single Shot. Two Shot. Three Shot. Over-the-Shoulder Shot (OTS) Point-of-View Shot (POV) For filmmakers and videographers, a major consideration for framing is the number of subjects you feature in your shots, and their physical relationship to each other and the camera. 68.8K subscribers Subscribe Subscribed 871 Share 130K views 3 years ago Once you've finished shooting that roll of 35mm it's time to SAFELY remove it from your camera. Just bare with me here Check how many photos you have left. Hold down the power button for two seconds and the film counter display will indicate how many shots you have left in the film pack. If the LED shows ‘0’ this means that there are no shots left in the film pack. The flash doesn’t fire when I take a photo. When using the film in this type of camera, the film will travel from one film spool to another. Once you have taken all of the images based on your camera design, make sure to advance the film all the way to the other spool. Then it is safe to open the camera and take the film out. Did your 35 camera just broke with a film inside ? Or maybe you want to use the same roll to test 3 different cameras ? Here's how to remove a film "mid-ro With your right hand, use the film advance lever to cock the camera. Look to make sure the film leader does not come out of the slot in the film take-up spool. Advance the film again. (Optional) If you are not confident the film is going to stay on the take-up spool, you can repeat step 6. Close the film door. Carefully close the film door. cYIhFj2.